개발자/Raspberry Pi3

DORJI DRF1276DM LoRa 모듈 timeout error 발생 해결 방법

지구빵집 2018. 2. 2. 21:00
반응형




DORJI DRF1276DM LoRa 모듈 UART 테스트 할 때 timeout error


결론만 말하자면 ADC02 보드의 EN 핀을 GND 로, LOW 로 잡아주면 된다.


 


위 사진 맨 아래 부분, 지금은 Successful 부분이 계속 Error:timeout 메세지가 떠서 자료를 찾아보니 


"This issue is because - pin 1 and pin 3rd on the DAC02 board is not connected. Please read page 10 -section 3.2 of "ADW1014_Testing_Data_Radio_Modem_With_Serial_Port_Tool.pdf" documentation, it says "Therefore we can solder a wire between 1st pin and 3rd pin on the back of DAC02 board to make the module enter into configuration mode." Once you do this, the problem is solved !"


이런 이유로 에러가 난 것이다. 아래 사진 처럼 EN -GND 를 쇼트 시키니 잘된다. 





자세한 설명과 필요한 Document 설명은 생략하는데 필요하신 분있으면 댓글 다시길. 그리고 같이 보면 좋은 내용


은   http://fishpoint.tistory.com/2644   참고하세요.






반응형